CONFIG_IDF_TARGET="esp32c6"

# Arduino Settings
CONFIG_FREERTOS_HZ=1000
CONFIG_AUTOSTART_ARDUINO=y

# Log Levels
# Boot Messages - Log level
CONFIG_BOOTLOADER_LOG_LEVEL_ERROR=y
# Arduino Log Level
CONFIG_ARDUHAL_LOG_DEFAULT_LEVEL_INFO=y
# IDF Log Level
CONFIG_LOG_DEFAULT_LEVEL_ERROR=y

# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y

# libsodium
CONFIG_LIBSODIUM_USE_MBEDTLS_SHA=y

# NIMBLE
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y
CONFIG_BT_NIMBLE_EXT_ADV=n
CONFIG_BT_NIMBLE_HCI_EVT_BUF_SIZE=70
CONFIG_USE_BLE_ONLY_FOR_COMMISSIONING=n

# FreeRTOS should use legacy API
CONFIG_FREERTOS_ENABLE_BACKWARD_COMPATIBILITY=y

# Enable OpenThread
CONFIG_OPENTHREAD_ENABLED=y
CONFIG_OPENTHREAD_SRP_CLIENT=y
CONFIG_OPENTHREAD_DNS_CLIENT=y
CONFIG_OPENTHREAD_LOG_LEVEL_DYNAMIC=n
CONFIG_OPENTHREAD_LOG_LEVEL_NOTE=y
CONFIG_OPENTHREAD_CLI=n

# Disable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=n

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions.csv"

# LwIP config for OpenThread
CONFIG_LWIP_IPV6_NUM_ADDRESSES=8
CONFIG_LWIP_MULTICAST_PING=y

# MDNS platform
CONFIG_USE_MINIMAL_MDNS=n
CONFIG_ENABLE_EXTENDED_DISCOVERY=y

# Enable OTA Requester
CONFIG_ENABLE_OTA_REQUESTOR=n

# Disable STA and AP for ESP32C6
CONFIG_ENABLE_WIFI_STATION=n
CONFIG_ENABLE_WIFI_AP=n

# Enable chip shell
CONFIG_ENABLE_CHIP_SHELL=n

# Disable persist subscriptions
CONFIG_ENABLE_PERSIST_SUBSCRIPTIONS=n

# MRP configs
CONFIG_MRP_LOCAL_ACTIVE_RETRY_INTERVAL_FOR_THREAD=5000
CONFIG_MRP_LOCAL_IDLE_RETRY_INTERVAL_FOR_THREAD=5000
CONFIG_MRP_RETRY_INTERVAL_SENDER_BOOST_FOR_THREAD=5000
CONFIG_MRP_MAX_RETRANS=3

# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y