This commit removes all references to the `xtools` toolchain variant in the
board YAML files.
Note that the `xtools` toolchain variant has been deprecated since Zephyr
v3.3.0 and now removed.
The removal process was automated using the following command line:
git grep -l xtools -- boards/*.{yml,yaml} | \
xargs -n 1 -P $(nproc) \
yq -i 'del(.toolchain[] | select(. == "xtools"))'
Signed-off-by: Stephanos Ioannidis <root@stephanos.io>
Creation of the new zephyr\soc\nxp\common\nxp_nbu.c driver which manage
the interruption of the NBU. This modification is mandatory to support a
coex application which includes Bluetooth and 802.15.4 on the same
narrow band path.
Signed-off-by: Xavier Razavet <xavier.razavet@nxp.com>
- Adds 'supported: flash' to all NXP board .yaml
with enabled flash controller support.
- Sorts supported features alphabetically.
Signed-off-by: Andrej Butok <andrey.butok@nxp.com>
SOCs using ECC require the SEGGER RTT control block address to be
provided to the tooling, as the SEGGER tools will not scan the memory
range of ECC ram. Add documentation making this clear to boards with
these SOCs.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
This updates the documentation of all the NXP boards to use
the new `zephyr:board::` directive.
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
For the "References" section to be useful, it needs to include a call to
the target-notes directive, which is the one that actually generates the
list of references made in the current document.
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
The Drivers using Pinctrl should be turning Pinctrl on
this should not be the responsibility of the board. This
commit removes CONFIG_PINCTRL from the boards side for nxp boards.
Signed-off-by: Emilio Benavente <emilio.benavente@nxp.com>
Enable LPI2C1 on the frdm_mcxw71 board which is connected to a
FXLS8964AF sensor (no driver for the sensor yet).
Signed-off-by: Declan Snyder <declan.snyder@nxp.com>
Full name was set based on the information available either in board
documentation or in Twister files.
Whenever applicable, vendor name was dropped from the full name so that
all boards have a consistent naming scheme.
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
Add timers that have been enabled to board doc table
Add timers that have been enabled to board twister yaml
Signed-off-by: Declan Snyder <declan.snyder@nxp.com>
