Remove Kconfig option that no longer has any use after pinctrl
driver is introduced.
Signed-off-by: Krzysztof Chruściński <krzysztof.chruscinski@nordicsemi.no>
Callback was set in uart_async_to_irq_rx_enable() which is only called
when RX is enabled. Callback shall be called in the init function.
uart_async_to_irq_init() signature changed to take device as the
input argument instead of data and config for the adaptation layer
(which can be retrieved from the device). Device is needed when
setting a callback during the initialization.
Signed-off-by: Krzysztof Chruściński <krzysztof.chruscinski@nordicsemi.no>
According to the API specification when RX error occurs receiver
shall be disabled. Adding missing disabling to the error handler.
Signed-off-by: Krzysztof Chruściński <krzysztof.chruscinski@nordicsemi.no>
This is needed to avoid warnings about uninitialized
structure member, which was added in nrfx 3.6.
Signed-off-by: Nikodem Kastelik <nikodem.kastelik@nordicsemi.no>
When RX length was 0 and error was reported then UART_RX_STOPPED event
was not sent. Fixing the condition check to ensure that UART_RX_STOPPED
is always generated.
Signed-off-by: Krzysztof Chruściński <krzysztof.chruscinski@nordicsemi.no>
Clean error state on re-enabling RX. If previous transmission ended with
an error it should not impact next receiving session.
Signed-off-by: Krzysztof Chruściński <krzysztof.chruscinski@nordicsemi.no>
Move providing of the first buffer in uart_rx_enable from that
function to the callback which is called from nrfx_uarte_rx_enable
context. By doing this nrfx_uarte_rx_buffer_set is called when
RX configuration flags are already known to the driver.
Signed-off-by: Krzysztof Chruściński <krzysztof.chruscinski@nordicsemi.no>
Just like for the old driver, for simulation, we cannot
get the UART regiter address for the pinctrl config structure
from DT, as that cannot match the one allocated at build time.
So let's override it at runtime with the correct address
which is stored in the UART config structure.
Also, do improve the condition for the busy wait during the poll_out,
for simulation, so we only busy wait if we will loop/the
Tx was busy.
Signed-off-by: Alberto Escolar Piedras <alberto.escolar.piedras@nordicsemi.no>
Add new shim which is based on nrfx driver.
Legacy shim is kept for transition period. It can be used after
setting CONFIG_UART_NRFX_UARTE_LEGACY_SHIM.
Signed-off-by: Krzysztof Chruściński <krzysztof.chruscinski@nordicsemi.no>
