Use shell_device_get_binding() instead of device_get_binding() so that
we get the device based on its name and in addition by its label.
Signed-off-by: Yishai Jaffe <yishai1999@gmail.com>
To remove CONFIG_PINCTRL from board side for numaker boards.
The Drivers using Pinctrl should be turning Pinctrl on
instead of the responsibility of the board.
Fixes#78619
Signed-off-by: cyliang tw <cyliang@nuvoton.com>
1. Support USB-C drivers TCPC, PPC, and VBUS with UTCPD H/W IP
2. UTCPD is interconnected with Timer-triggered EADC for updating
VBUS/VCONN voltage periodically
Signed-off-by: Chun-Chieh Li <ccli8@nuvoton.com>
Add driver for NXP nx20p3483 power path controller that can be used
to control and protect sink and source path of USB-C connector.
Signed-off-by: Michał Barnaś <mb@semihalf.com>
Add support for ppc shell command with subcommands that can print
the status of PPC (dead battery, sinking, sourcing, vbus detected),
dump registers and request the PPC to exit dead battery mode.
Signed-off-by: Michał Barnaś <mb@semihalf.com>
This commit adds an API to the Power Path Controllers (PPC) that
may be used with USB-C subsystem to control the current paths,
enabling and disabling sourcing and sinking VBUS and protect against
shorts, overvoltage and overcurrent.
Signed-off-by: Michał Barnaś <mb@semihalf.com>
