LinkServer can flash only the first time, cannot flash again.
Fix it by setting default mcu security status as unsecure.
Signed-off-by: Michal Smola <michal.smola@nxp.com>
NXP PORT IP instantiations often have different features absent, IE
input buffer, open drain, or slew rate support. Check if the relevant
PCR register bitmasks are defined in the common pin control file, and
define the bitmasks to 0x0 (no effect) if they are not. This allows us
to further consolidate the pinctrl_soc.h headers for SOCs using the PORT
IP.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
HAS_SEGGER_RTT Kconfix symbol is missing in NXP MCXC series Kconfig.
Add the symbol to fix and enable Segger RTT samples.
Signed-off-by: Michal Smola <michal.smola@nxp.com>
Bandgap voltage is used for on die temperature measurement. Bandgap
buffer has to be enabled explicitly to get correct tempearature.
Enable the buffer if TEMP_KINETIS is selected.
Signed-off-by: Michal Smola <michal.smola@nxp.com>
Timer/PWM Module (TPM) initial clock source is not selected.
Add initial clock source selection based on Devicetree configuration.
Rename clock sources definitions from LPUART specific to general names
usable by several modules on the SoC.
Signed-off-by: Michal Smola <michal.smola@nxp.com>
Generic hook infrastrucutre was added to Zephyr, but NXP MCXC SoCs
were not updated accordingly.
Use generic hook infrastrucutre for MCXC SoCs.
Signed-off-by: Michal Smola <michal.smola@nxp.com>
