Convert them to native YAML lists. Support for space-separated
lists was deprecated in Twister a long time ago.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Change the unit of the sense resistor in the devicetree binding from
micro-ohms to milli-ohms. This is done for three reasons.
Firstly, the maximum value resistor that can currently be represented
is 4.2 kOhms, due to the limitation of devicetree properties to 32 bits.
Secondly, storing the resistance at such a high resolution makes
overflows much more likely when the desired output unit is micro-amps,
not milli-amps.
Finally, micro-ohms, are an unnecessarily precise unit for the purpose
of these calculations, and a resolution that is not realistic to
achieve. The high resistor resolution results in large divisors that
reduce the resolution of outputs. Unlike resistors characterised down to
the micro-ohm, devices wanting to measure micro-amps are actually
realistic.
Signed-off-by: Jordan Yates <jordan@embeint.com>
During the hwmv1->v2 transition, overlays from a base
board were made to be shared with the variants.
So at that time all overlays for variants which were
just copies of the base overlay were removed.
After that in
https://github.com/zephyrproject-rtos/zephyr/pull/71149
this shared/merged overlay behaviour was reverted,
but not all tests were fixed.
This is one of those. Let's fix it.
Signed-off-by: Alberto Escolar Piedras <alberto.escolar.piedras@nordicsemi.no>
For the 64 bit targets, change identifiers to the new hwmv2 ones.
And remove redundant overlays (which were equal for the 32
and 64 bit versions)
Signed-off-by: Alberto Escolar Piedras <alberto.escolar.piedras@nordicsemi.no>
Switch from native_posix to native_sim as default test platform.
For test with overlays, switch overlays and platform_allow from
native_posix to native_sim.
For tests without overlays, enable also in native_sim, and
set native_sim as integration platform.
Signed-off-by: Alberto Escolar Piedras <alberto.escolar.piedras@nordicsemi.no>
