Use the mipi_dbi_configure_te API within the st7796s display driver.
If the MIPI DBI controller supports the tearing enable signal, then
configure the ST7796S to output the TE line signal.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Use a string for the mipi-mode property over an integer value, as this
significantly improves the readability of the MIPI DBI device binding.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Update ST7796s display driver to respect the setting of rgb_is_inverted
in 8080 8 bit mode, as it was previously not applied for this mode.
Also, simplify the logic check for 16 bit mode- the new check is
functionally equivalent, but no longer inverts both boolean values.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
1. Add a property for panels where the RGB is displayed as BGR.
2. Add a check for 8080 8-bit mode and invert RGB and BGR for
this case.
Signed-off-by: Mahesh Mahadevan <mahesh.mahadevan@nxp.com>
Remove unused includes and gpio pins from st7796s driver, which were
leftover from before this driver used the MIPI DBI API class.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Add driver for ST7796s display. This is a MIPI DBI display controller,
with a frame memory of 320x480x18 pixels. Support for 4 wire SPI mode is
implemented using the MIPI DBI API.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
