Separate the current driver for the FPGA iCE40 into two different ones.
One implements only the SPI load mode, the other one only the GPIO
bitbang mode.
Signed-off-by: Benedikt Schmidt <benedikt.schmidt@embedded-solutions.at>
Replace the DT_INST_PROP_OR statements with defaults
in the devicetree binding of the iCE40.
Signed-off-by: Benedikt Schmidt <benedikt.schmidt@embedded-solutions.at>
Replace the enum for load modes for the iCE40 with a boolean flag,
as there are only two options:
- SPI: default, which should be used whenever possible
- GPIO bitbang: workarorund, in case a low-end microcontroller is used
Signed-off-by: Benedikt Schmidt <benedikt.schmidt@embedded-solutions.at>
The 200ns reset time specified in the datasheet are a minimum time; and the
nanoseconds were being rounded to whole microseconds anyway.
Also make it the same type as `config_delay_us` (`uint16_t`).
Signed-off-by: Armin Brauns <armin.brauns@embedded-solutions.at>
From FPGA-TN-02001-3.3 "iCE40 Programming and Configuration":
> After driving CRESET_B High or allowing it to float High, the AP must
> wait a minimum of 1200 µs, allowing the iCE40 FPGA to clear its internal
> configuration memory.
Signed-off-by: Armin Brauns <armin.brauns@embedded-solutions.at>
