This changes storage.mount() to require that a mount point exist
on the parent file system.
A bug in background tasks is also fixed where the function
parameter is cleared on pending callbacks during "reset".
Disk usage is shown on the directory listing and changes based on
the mounted file system. Writable is also loaded per-directory.
Fixes#8108. Fixes#8690. Fixes#8107.
micropython puts the pointer-ness into the typedef; we can put the
const-ness there too.
this reduces the delta to micropython; for instance, emitinlinextensa
and emitinlinethumb now match upstream.
.. which is what the addition of cmd25 made happen. We still signal
an error when failing to reach the idle state at any other time,
which _is_ different than adafruit_sdcard but I think that it is
correct.
This fixed#5600 according to Dan's testing on a GCM4 on the internal
SD card slot. There are still some ambiguous results on the MM4 with
external SD card slot on 6" jumper wires.
This targets the 64-bit CPU Raspberry Pis. The BCM2711 on the Pi 4
and the BCM2837 on the Pi 3 and Zero 2W. There are 64-bit fixes
outside of the ports directory for it.
There are a couple other cleanups that were incidental:
* Use const mcu_pin_obj_t instead of omitting the const. The structs
themselves are const because they are in ROM.
* Use PTR <-> OBJ conversions in more places. They were found when
mp_obj_t was set to an integer type rather than pointer.
* Optimize submodule checkout because the Pi submodules are heavy
and unnecessary for the vast majority of builds.
Fixes#4314
This increases write rates (of gifio from #5490) from about 2.4fps to over
5fps by making more efficient use of the SD card protocol.
Because of details of oofatfs, it usually manages 64 writes in a single
CMD25, then two writes in a different area of the SD card (presumably,
filesystem metadata). I couldn't find where to increase "64" to a higher
number. This may depend on the allocation size of the filesystem.
I tried preallocating too, but oddly it significantly lowered the write
rate.
Any trailing data is committed when the file is close()d, or when
the `sync` method of the SDCard object is called.
The RP2040 is new microcontroller from Raspberry Pi that features
two Cortex M0s and eight PIO state machines that are good for
crunching lots of data. It has 264k RAM and a built in UF2
bootloader too.
Datasheet: https://pico.raspberrypi.org/files/rp2040_datasheet.pdf
Testing performed: That a card is successfully mounted on Pygamer with
the built in SD card slot
This module is enabled for most FULL_BUILD boards, but is disabled for
samd21 ("M0"), litex, and pca10100 for various reasons.
