This commit adds preliminary support for ST's new STM32N6xx MCUs.
Supported features of this MCU so far are:
- basic clock tree initialisation, running at 800MHz
- fully working USB
- XSPI in memory-mapped mode
- machine.Pin
- machine.UART
- RTC and deepsleep support
- SD card
- filesystem
- ROMFS
- WiFi and BLE via cyw43-driver (SDIO backend)
Note that the N6 does not have internal flash, and has some tricky boot
sequence, so using a custom bootloader (mboot) is almost a necessity.
Signed-off-by: Damien George <damien@micropython.org>
Options for a board to configure ROMFS are:
- Leave ROMFS disabled, do nothing.
- Enable by defining `MICROPY_HW_ROMFS_ENABLE_PARTx` to 1 and then in the
linker script define `_micropy_hw_romfs_partX_start` and
`_micropy_hw_romfs_partX_size`.
- Enable by defining `MICROPY_HW_ROMFS_ENABLE_PARTx` to 1 and also define
`MICROPY_HW_ROMFS_PARTx_START` and `MICROPY_HW_ROMFS_PARTx_SIZE` which
can be arbitrary expressions (not necessarily static)
Signed-off-by: Damien George <damien@micropython.org>
Change ROMFS partition configuration variables to use index 0 as the
starting partition number (instead of index 1).
Reasons to do this:
- `vfs.rom_ioctl()` numbers the partitions starting from 0
- `mpremote romfs -p <partition id>` numbers the partitions starting from 0
Signed-off-by: Damien George <damien@micropython.org>
This commit implements `vfs.rom_ioctl()` to query, erase and write both
internal and external flash, depending on how the board configures its
flash memory.
A board can configure ROM as follows.
To use internal flash memory:
#define MICROPY_HW_ROMFS_ENABLE_INTERNAL_FLASH (1)
To use external flash memory (QSPI memory mapped):
#define MICROPY_HW_ROMFS_ENABLE_EXTERNAL_QSPI (1)
#define MICROPY_HW_ROMFS_QSPI_SPIFLASH_OBJ (&spi_obj)
Then the partition must be defined as symbols in the linker script:
_micropy_hw_romfs_part1_start
_micropy_hw_romfs_part1_size
And finally the partition needs to be enabled:
#define MICROPY_HW_ROMFS_ENABLE_PART1 (1)
There's support for a second, optional partition via:
_micropy_hw_romfs_part2_start
_micropy_hw_romfs_part2_size
#define MICROPY_HW_ROMFS_ENABLE_PART1 (1)
Signed-off-by: Damien George <damien@micropython.org>
