- Add support CAN-FD for EK-RA6E2, EK-RA4E2
- Enable ioport for can-transceiver on EK-RA6E2, EK-RA4E2
Signed-off-by: Khoa Nguyen <khoa.nguyen.xh@renesas.com>
Gap filling in hex files are now disabled per default, and therefore
there is no reason to explicitly disable gap filling.
It has never been possible to disable gap filling in binary files.
Disabling gap filling would just result in the binary file to be gap
filled with the tool's default value, objcopy=0x00.
Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>
Full name was set based on the information available either in board
documentation or in Twister files.
Whenever applicable, vendor name was dropped from the full name so that
all boards have a consistent naming scheme.
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
Move the process of replacing numerical values with macros to
the header, and set the division ratio in a numeric without
using macros in the device tree.
Change `clk-div` defined in `renesas,ra-cgc-pclk.yaml` to `div`.
Signed-off-by: TOKITA Hiroshi <tokita.hiroshi@gmail.com>
DeviceTree typically references the clock source using the `clocks`
property defined in `base.yaml`, so we'll change it to this.
Also delete the custom clock source definitions in
`renesas,ra-cgc-pclk-block.yaml`, `renesas,ra-cgc-pclk.yaml`, and
`renesas,ra-cgc-pll.yaml`.
Signed-off-by: TOKITA Hiroshi <tokita.hiroshi@gmail.com>
Background of this modification is to make clock control
driver code provided by Renesas vendor to support for Renesas MCU
on Zephyr.
Signed-off-by: Quy Tran <quy.tran.pz@renesas.com>
